15FW65P1 LF Drivers 15 inchs
            Notes
- 2.5 INCH COPPER VOICE COIL
 
- 97 dB/SPL SENSITIVITY
 
- 700 WATT PROGRAM POWER HANDING
 
- FEM OPTIMIZED MOTOR AND SUSPENSIONS
 
- OPTIMIZED COOLING SYSTEM
 
- RESONANCE FREE AND HEAVY DUTY BASKET DESIGN
          - 97 dB/SPL SENSITIVITY
- 700 WATT PROGRAM POWER HANDING
- FEM OPTIMIZED MOTOR AND SUSPENSIONS
- OPTIMIZED COOLING SYSTEM
- RESONANCE FREE AND HEAVY DUTY BASKET DESIGN
GENERAL SPECIFICATIONS
| Nominal diameter | 386(15) mm (in.) | 
|---|---|
| Nominal impedance | 8 Ω | 
| Minimum impedance | 6.1 Ω | 
| Program power (1) | 700 W | 
| AES Power rating(2) | 350 W | 
| Sensitivity (3) | 97 dB | 
| Frequency range | 46 ~ 3000 Hz | 
| Voice coil diameter | 65(2.5) mm (in.) | 
| Chassis material | Steel | 
| Magnet material | Ferrite | 
| Magnet dimensions (ODxIDxh) | 170 x 85 x 20 mm | 
| Coil material | SV | 
| Former material | Glass Fiber | 
| Xmax(4) | 5 mm | 
| Xmech(5) | 9 mm | 
| Gap height | 8 mm | 
| Voice coil Winding height | 14 mm | 
SMALL SIGNAL PARAMETERS
| DC resistance(Re) | 4.5 Ω | 
|---|---|
| Resonance frequency(Fs) | 46 Hz | 
| Moving mass(Mms) | 82 g | 
| Compliance(Cms) | 0.13 mm/N | 
| Force factor(BL) | 18.2 N/A | 
| Mechanical Q-factor(Qms) | 5.1 | 
| Electrical Q-factor(Qes) | 0.52 | 
| Total Q-factor(Qts) | 0.47 | 
| Equivalent air volume(Vas) | 137 I | 
| Voice coil Inductance(Le) | 0.71 mH | 
| Diaphragm area(Sd) | 880 cm2 | 
| Reference efficiency(Eta O) | 2.2 % | 
SHIPPING INFORMATION
| Net weight | 5 Kg | 
|---|---|
| Multipack size (2) (W x D x H) | 410 x 410 x 378 mm | 
| Multipack weight | 10.8 Kg | 
OTHERS
(1)Program power is defined as 3 dB greater than AES Power.
(2) Tested for two hours using a continuous, band-limited pink noise signal as per AES 2-1984 Rev. 2003. Loudspeaker tested in free air.
(3) From T/S parameters, measured with LMS DA LPM module.
(4) The Xmax is calculated as: (Hvc - Hg)/2+ Hg/4. Hvc is the voice coil height and Hg the gap height.
(5) The Xmech is calculated as: (Hvc - Hg)/2 +(Hg-2). Hvc is the voice coil height and Hg the gap height.
(6) Thiele-Small parameters are measured after preconditioning: a) at 20°C- 22°C, 50% humidity for 2 hours; b) by LMS LSI measurement.
          (2) Tested for two hours using a continuous, band-limited pink noise signal as per AES 2-1984 Rev. 2003. Loudspeaker tested in free air.
(3) From T/S parameters, measured with LMS DA LPM module.
(4) The Xmax is calculated as: (Hvc - Hg)/2+ Hg/4. Hvc is the voice coil height and Hg the gap height.
(5) The Xmech is calculated as: (Hvc - Hg)/2 +(Hg-2). Hvc is the voice coil height and Hg the gap height.
(6) Thiele-Small parameters are measured after preconditioning: a) at 20°C- 22°C, 50% humidity for 2 hours; b) by LMS LSI measurement.
